Addressed Defects in SwyxWare v6.02 (kb3417)

The information in this article applies to:

• SwyxWare Administration v6.02
• SwyxIt! v6.02
• SwyxFax Server v6.02
• SwyxFax Client v6.02
• SwyxWare v6.02
• SwyxFax Server v6.01
• SwyxFax Client v6.01
• SwyxIt! v6.01
• SwyxWare v6.01
• SwyxWare Administration v6.01

[ Summary | Information ]

Summary

Information

Beside the new extensions described in Knowledge Base article Summary of changes within SwyxWare v6.02 (kb3416)SwyxWare v6.02 addresses the following issues:

• Old entries will not be deleted from table "ChangeNotificationSubscription".
  (Swyx00014499)
• In special scenarios SwyxPhone locks up because of a deadlock in PhoneManager on notification calls.
  (Swyx00014890)
• Increase late disconnect timeout in gateway to match ISDN T306 on network side.
  (Swyx00014046)
• In special scenarios standalone gateway does not register trunks automatically after failover.
  (Swyx00014259)
• Sending/Receiving faxes via internal S0 does not work reliable in special scenarios
  (Swyx00014017)
• Phone does not ring in situations with extreme server load.
  (Swyx00014830)
• Deleting gateway trunks without any configuration takes too long
  (Swyx00013898)
• In special scenarios ISDN driver does not detect layer 1 after very short interruption.
  (Swyx00014129)
• Primary/Fallback server switching in fax client fails in special scenarios
  (Swyx00014161)
• It's impossible to stop SwyxFax Server via SwyxFax Administration if the network connection is interrupted
  (Swyx00010236)
• No online help in SwyxFax Administration menus in German version.
  (Swyx00013069)
• FaxServer enter to endless loop in special conditions.
  (Swyx00013524)
• Sheduled faxes become "ERROR" state after FaxServer restart.
  (Swyx00013525)
• SwyxFax Server and FaxClient hangs up during mass fax sending.
  (Swyx00013424)
• Conversation recording is stopped on knocking sound when micro is muted.
  (Swyx00014248)
• Slow speed dial status change after intercom call.
  (Swyx00014288)
• SwyxIt! as CTI Slave switches lines slowly.
  (Swyx00013817)
• In special scenarios Switch-on Media streaming is delayed.
  (Swyx00014081)
• Client exe crashes on Logoff after disconnecting VPN connection.
  (Swyx00014811)
• In special scenarios ConferenceManager stops to process conference calls.
  (Swyx00013034)
• Ad-hoc conference fails if conference user always prompts for PIN authorization.
  (Swyx00012981)
• In special scenarios Database restore fails.
  (Swyx00014497)
• Wrong Autologin after Reboot.
  (Swyx00013990)
• Swyx DECT handset does not show the calling party name.
  (Swyx00013838)
• Sometimes trunks loose their registration for a short period.
  (Swyx00013951)
• Incoming SIP trunk call to Swyx DECT 800 fails.
  (Swyx00014091)
• Swyx DECT: No ringing tone on outgoing ISDN calls.
  (Swyx00014613)
• It's not possible to fetch voicemails using Remote Inquiry with MS Exchange Server 2007.
  (Swyx00014092)
• Conversation record isn't saved if destination folder is changed without SwyxLink restart.
  (Swyx00012605)
• The trunk assignment in the LinkManager does not work on the basis Recognition-URI.
  (Swyx00014240)
• Incoming calls from some SIP providers don't work.
  (Swyx00013979)
• Incoming SIP trunk call using compression is disconnected after "ConnectTo group".
  (Swyx00014041)
• In special scenarios LinkManager dumps on concurrent DTMF and disconnect events.
  (Swyx00014388)
• Incoming calls via Toplink do not work after a couple of days.
  (Swyx00014312)
• DTMF on incoming call via LinkManager do not work if DTMF is started in the alerting state.
  (Swyx00014275)
• Number Replacement profile "Transparent" doesn't work as expected for ISDN.
  (Swyx00014112)
• Number suppression does not work if this is configured on SwyxPhone line.
  (Swyx00013684)
• Hidden number in global phonebook is displayed on SwyxPhones.
  (Swyx00013778)
• SwyxPhone does not re-logon automatically after it was logged off by Administrator.
  (Swyx00014022)
• In special scenarios deadlock in PhoneManager caused hanging threads in the Server.
  (Swyx00014891)
• Estimated call time in parameter "Average call time" in "Set Queue Attributes" GSE block should be done in minutes.
  (Swyx00014016)
• In special scenarios SwyxGate throws access violation.
  (Swyx00014033)
• Call get stuck in Gateway if "ConnectReq" is not confirmed by ISDN driver.
  (Swyx00014084)
• Under special circumstances no incoming calls are accepted any more.
  (Swyx00013960)
• Gateway in standby scenario does not register all trunks at switchover.
  (Swyx00014454)
• Standalone Gateway does not register at server in standby environment.
  (Swyx00014780)
• Gateway crashes on receiving "AOC-S" via ISDN.
  (Swyx00014322)
• In special scenarios no SSL connection to Mail Server possible because loading of SSL helper libraries "libeay32.dll" and "slleay32.dll" failed.
  (Swyx00012864)
• French version: Unsupported sampling rate for some SwyxWare wav files.
  (Swyx00013403)
• Transfer to Swyx DECT 800 user in group Sales via Operator script fails.
  (Swyx00013787)
• SwyxWare internal calls are signalled as external calls on Swyx DECT handset.
  (Swyx00013837)
• Standby: network failure between Main SwyxServer and Standby SwyxServer leads to a forced log off of clients.
  (Swyx00014027
• In special scenarios Testmail can not be sent to some mail servers.
  (Swyx00014410)
• Group call notifications configured with relations do not work if call was redirected.
  (Swyx00013340)
• GetDTMFChar only works if call is accepted via "PlaySound" before.
  (Swyx00013177)
• Incoming calls on SIP trunk get disconnected when being transferred.
  (Swyx00013943)
• Blind call transfer information not displayed.
  (Swyx00014173)
• Call transfer to CallQueue script fails if transfer is initiated via drag'n drop to speed dial key.
  (Swyx00013861)
• Call transfer to CallQueue script fails if transfer is initiated while CallQueue call is on hold.
  (Swyx00013862)
• Call transfer to CallQueue script fails if transfer is initiated while CallQueue call is delivered to Group.
  (Swyx00013863)
• Permanent license file not accepted when no IDE controller present.
  (Swyx00013904)
• Activation of external call on hold fails, if call was also delivered to parallel target.
  (Swyx00013905)
• Audiocodes redundant mode does not work together with SwyxWare Standby.
  (Swyx00014076)
• Incorrect number of repetitions in the "Get DTMF char" block.
  (Swyx00011462)
• Hunt group call handling very slow is case of multiple busy group members using SIP based client.
  (Swyx00014229)
• Calls from ISDN at SwyxConnect get lost when they are put on hold via script or parked in call queue.
  (Swyx00014478)
• Master/Standby configuration wizard will be restarted in case of wrong domain admin username or password.
  (Swyx00013376)
• Forwarding, secondary call, number suppression do not always work in a master/standby system.
  (Swyx00013908)
• Unexpected error when adding an additional permanent license key.
  (Swyx00013793)
• Missing meaningful error message when trying to add "Swyx Update Service" licenses within Administration.
  (Swyx00010456)
• Operator user has no short name.
  (Swyx00012898)
• Number mapping disappears trying to map a second number which was already in use.
  (Swyx00012918)
• T-Online (DE) SIP profile does not work with modified settings.
  (Swyx00013002)
• SwyxWare Administration overview page displays wrong license information in case of quitting server properties by 'Cancel' button.
  (Swyx00013050)
• In special scenarios it is impossible to delete user correctly at SwyxWare Administration
  (Swyx00013149)
• Administration offers codices for trunk recording which don't work in case additional recording codices are added via xml file.
  (Swyx00013252)
• In special scenarios Public numbers are unexpectedly deleted within SwyxWare Administration.
  (Swyx00013321)
• For some special scenarios Snom phones do not work correctly.
  (Swyx00013502)
• SwyxWare Administration does not display correct icons.
  (Swyx00013872)
• All number mappings disappear if SwyxLink is deleted.
  (Swyx00013876)
• SwyxWare Administration does not work correctly on systems with two active network cards.
  (Swyx00013909)
• It's not possible to disconnect a registered SIP trunk.
  (Swyx00013974)