Swyx Knowledgebase

HOWTO

Initial configuration of tiptel innovaphone 21 (IP21) for interoperability with SwyxWare (kb2315)

 

The information in this article applies to:

  • SwyxWare v4.13
  • SwyxWare v4.12
  • SwyxWare v4.11
  • Innovaphone IP21 4.x
  • SwyxWare v4.02

[ Summary | Information | Links ]


Summary

This article describes the initial configuration of IP21 by Webinterface (enter IP address of device) after reset/using factory defaults.

The latest firmware version being tested with SwyxWare is

  • v4.00 sr2 [02-4283] (see download reference below)

Information

To start configuration window:

  • Click Gateway Config
      (or 'Administration: Config edit' until firmware 4.00 rc1)
  • Login using default user/password (admin/ip21)
  • Choose Config/IP Interfaces/Ethernet Interface
  • Set DHCP Mode to Client

Configuring analog line 1 (using GW1/TEL1):

  • Choose Config/VoIP Interfaces/Undefined GW1
  • Set Mode to Registration at gatekeeper as endpoint
  • Set Remote gatekeeper address/IP address to IP address of IpPbxServer
  • Choose Config/VoIP Interfaces/GW1
  • Click button Add alias
  • Enter H.323 alias of terminal adapter user (as configured in SwyxWare Administration) in H.323 Name

  • Choose Config/Routing table
  • Click button Add route
  • Choose Config/Routing table/Route/->TEL1
  • Set Enable calls from interfaces to GW1 => Route GW1->TEL1
  • Click button Add map
  • Fields could be left empty
  • Set Destination: to TEL1

  • Choose Config/Routing table
  • Click button Add route
  • Choose Config/Routing table/Route/->TEL1
  • Set Enable calls from interfaces to TEL1
  • Set Default call destination to GW1 => Route TEL1->GW1
  • Click button Add map
  • Fields could be left empty
  • Set Destination: to GW1

To configure IP21 for T.38 (Fax over IP) protocol (SwyxWare >= v4.02)

  • Choose Config/VoIP Interfaces/GW1
  • Set Enable T.38 fax protocol flag

    T.38 configuration
    T.38 configuration
    Click to enlarge...

Click buttons Activate and Save to activate and save the new settings.

To configure analog line 2 the same procedure should be done using GW2/TEL2 instead of GW1/TEL1.

 

Note:

Do not configure the IP21 and the SwyxWare to TCP but instead use the default UDP. The SwyxWare is currently not compatible to the IP21-TCP. The Knowledgebase article Usage of Fax T.38 via TCP instead of UDP (kb2291) is meant for stand-alone SwyxGates being used for internal S0/S2m lines to connect FAX devices to.


Links

As far as software supplied or used by us, includes open source elements the additional terms under https://www.swyx.com/open-source apply in addition. An overview which products from the Swyx portfolio include open source elements and which open source license is relevant can be found under https://www.swyx.com/open-source.

The third-party contact information included in this article is provided to help you find the technical support you need. This contact information is subject to change without notice. Swyx in no way guarantees the accuracy of this third-party contact information nor is responsible for it's content.