SIP Provider willy.tel (DE) (kb5250)
The information in this article applies to:
- SwyxWare 11
Information und configuration hints for SIP provider willy.tel (Germany)
The SIP Trunk from willy.tel was first tested and released with SwyxWare 184.108.40.206.
The SIP Trunk from willy.tel is a SIP Trunk with user authentication, i.e. you receive information on user ID, user name and password. The names may differ, or you may only receive a name or ID with password. In this case the user ID is identical to the user name when configuring the SIP trunk in SwyxWare.
In addition to the authentication information, the public IP address of the SwyxWare Server is also checked. You therefore need a static, public IP address from your ISP via which the SIP proxy of willy.tel communicates with SwyxWare.
SwyxWare: The SIP Trunk from willy.tel can be used from SwyxWare 220.127.116.11 on. When using an earlier version of SwyxWare incompatibilities cannot be excluded and use is at your own risk.
SwyxON: The SIP Trunk from willy.tel is not suitable for central connection in the data center.
When creating the SIP trunk group, select the profile 'willy.tel (DE)'. If the profile is not included in the corresponding list, you can download the required CustomProviderProfiles.config for SwyxWare at the end of this article. For more information about using this file, see Configuration and Adaptation of SIP Providers via Provider Profiles (kb3436).
In order to assign incoming calls to the correct trunk, it is necessary to configure a SIP URI for the trunk. The assigned number block and the numberformat must be considered.
Numberblock: +41 40 123456780 ... +41 40 123456789
In this case, the SIP URI must be entered in the format +494012345678*@*.
Afterwards, the LinkMgr service has to be restarted.
In the codec dialog G.722, G.711u and G.729 can be deselected. T.38 has to be deselected as supported codec.
- Incoming/outgoing national /international calls
- Correct Calling Line Identification (CLI) on national / intenational calls
- CLIP No Screening
- Holding and retrieving calls
- Toggeling between two calls
- Call transfer
- Call forwarding
Mutually supported codecs:
- Incoming/outgoing DTMF signaling in accordance with via RFC2833
- FAX transmission via G.711
- Fax transmission via T.38
14/05/2019 with SwyxWare 18.104.22.168
The third-party contact information included in this article is provided to help you find the technical support you need. This contact information is subject to change without notice. Swyx in no way guarantees the accuracy of this third-party contact information nor is responsible for it's content.