SIP Provider intersaar (DE) (kb5215)
The information in this article applies to:
- SwyxWare 11
Information und configuration hints for SIP provider intersaar (Germany)
The SIP Trunk from intersaar was first tested and released with SwyxWare 220.127.116.11.
The SIP Trunk from intersaar is a SIP Trunk with user authentication, i.e. you receive information on user ID, user name and password. The names may differ, or you may only receive a name or ID with password. In this case the user ID is identical to the user name when configuring the SIP trunk in SwyxWare.
SwyxWare: The SIP Trunk from intersaar can be used from SwyxWare 18.104.22.168 on. When using an earlier version of SwyxWare incompatibilities cannot be excluded and use is at your own risk.
SwyxON: The SIP Trunk from intersaar is suitable for central connection in the data center.
When creating the SIP trunk group, select the profile 'intersaar (DE)'. If the profile is not included in the corresponding list, you can download the required CustomProviderProfiles.config for SwyxWare at the end of this article. For more information about using this file, see Configuration and Adaptation of SIP Providers via Provider Profiles (kb3436).
In order to assign incoming calls to the correct trunk, it is necessary to configure a SIP URI for the trunk. The assigned number block and the numberformat must be considered.
Numberblock: +49 40 1234560 ... +49 40 1234569
In this case, the SIP URI must be entered in the format +4940123456*@*.
Afterwards, the LinkMgr service has to be restarted.
A connection to intersaar trunk requires a STUN server, which is provided by intersaar themselves. This STUN server uses the default port 3478. The networking environment (NAT, firewall) has to allow communication with that port.
- Incoming/outgoing national /international calls
- Correct Calling Line Identification (CLI) on national / intenational calls
- CLIP No Screening national
- Holding and retrieving calls
- Toggeling between two calls
- Call transfer
- Call forwarding
Mutually supported codecs:
- Incoming/outgoing DTMF signaling in accordance with via RFC2833
- FAX transmission via T.38/G.711
- Number supression (CLIR) by outgoing calls is not supported
05/03/2019 with SwyxWare 22.214.171.124
- CustomProviderProfiles_intersaar (DE)
The third-party contact information included in this article is provided to help you find the technical support you need. This contact information is subject to change without notice. Swyx in no way guarantees the accuracy of this third-party contact information nor is responsible for it's content.