INFO

TPP: Plantronics Headset Blackwire C520 - SwyxIt! 2015 (kb4698)

The information in this article applies to:

  • SwyxWare 2015
  • SwyxIt! 2015
  • Plantronics Headsets

[ Summary | Information ]


Summary

Within the Swyx Technology Programme (TPP) the Plantronics Headset Blackwire C520  was successfully tested with a SwyxIt! 2015 and reaches therefore the certification level certified.


Information

General

The Plantronics Blackwire C520 is a corded USB headset with an integrated inline control. For operation with the SwyxIt!, it is necessary to install the Plantronics Hub software, which can be downloaded from  http://www.plantronics.com/de/product/plantronics-hub-desktop/. The installed software allows to configure some general Plantronics settings. There is no device specific configuration for the C520.

1. Test

1.1 Testenvironment
SwyxWare: V2015
SwyxIt!.exe: V10.0.0.143
CLMgr.exe: V10.0.0.176

Plantronics Hub Software:  V3.4

BlackWire C520 Firmware: USB v.136

Test-PCs:
HP Compac DC5100 MT, Win7, SP1
HP Compac 6000 Pro MT, Win8
HP Pro 3520, Win8.1

Basic settings:
Windows Default Speaker: Internal Speaker
Windows Default Microphone: Plantronics C520

SwyxIt! Headset:  Plantronics C520
SwyxIt! Signaling: Internal Speaker
SwyxIt!: No additional ringing on internal speaker

Plantronics Hub: C520 as primary device
Ringtones on primary device only

Test date:
08-05-2015

1.2 Executed tests

The tests were classified into

  • Installation and configuration
  • Accepting and terminating calls
  • Mute
  • Volume control
  • Unplug and replug of C520

The tests completed successfully; the different test PCs or operating systems did not influence the test results.

1.3 Notes

  • If the SwyxIt! is configured to play the ringtones on the C520 instead of the internal PC speaker, the volume of the ringtones can only be adjusted by the C520 itself, using the appropriate configuration dialog or during an incoming call.
  • If the SwyxIt! is muted by the SwyxIt! control during an incoming call or in idle state, the mute LED on the inline control of the C520 remains off.
    If the mute button is pressed on the inline conrol of the C520 during an incoming call or in idle state, the mute control of the SwyxIt! remains unchanged (unmuted).
    In both cases, if the call is accepted or during call establishment, the itself is muted.
  • By pressing the call button of the inline control for a longer period during an existing call, it is possible to put a call on hold or to retrieve a held call.

1.4 Ringtones

During in incoming call, no Plantronics ringtone is played by the C520.

Depending on the configured ring location in the plantronics Hub Software and the ringing device in the SwyxIt!, the SwyxIt! ring tone and the Plantronics ringtone might interfere.

2 Installation and configuration

SwyxIt! 2015 must be installed. Exit SwyxIt!!
Install Plantronics Hub Software
Plug in the C520 to a free USB port.
Start the SwyxIt!
Control and configure the Windows Audio Settings and the SwyxIt! Audio Modes if necessary.


Comment

Comment on this article



If we have any follow-up questions, where can we contact you?

E-Mail Address (optional)


Note

This feedback form can't be used for support requests. Those requests must be directed to your Swyx reseller or distributor.