New Firmware for all SwyxPhones available (V2 R0.95.0) (kb4484)

The information in this article applies to:

  • SwyxWare 2011 R2
  • SwyxWare 2011
  • SwyxPhone L615

[ Summary | Information ]


Swyx has released a new firmware V2 R0.94.0 for the SwyxPhones L615 (g) .

Please note that...

  •  this firmware can only be used with the following SwyxWare versions:

    • SwyxWare 2011 or higher 
  • the gigabit variant of the L615 can only be used with the following firmware versions:
    • V2 R0.94.0 or higher
    • V2 R0.92.2


For the error-free operation of the phones of type L615g (Gigabit variant) the new firmware V2 R0.94.0 was mandatory. With this firmware update all phones types can operate using the same software version, again.


If the L615g phones operate with a lower firmware versions than V2 R092.2 the function ofthe complete phone will be impaired. An upgrade to the necessary software version is not possible! Repair will be possible only by the vendor itself.

To update the firmware at your SwyxServer you have to perform the following steps related to the installed SwyxWare version:

Open the Server Settings within the SwyxWare Administration and select the tab "SwyxPhone Firmware Update". Within this configuration select the option "Get". Hereby the SwyxServer will contact the Swyx FTP server ( which is configured by default and downloads the latest firmware version information.

After this you could validate if you should update your SwyxPhones by checking the firmware version information: If the firmware version (V2 R0.95.0) is listed for the SwyxPhones, the phones will prompt for a firmware upgrade the next time the user logs on.

You will find the new firmware also as single download on the Swyx Download Page.


Comment on this article

If we have any follow-up questions, where can we contact you?

E-Mail Address (optional)


This feedback form can't be used for support requests. Those requests must be directed to your Swyx reseller or distributor.