HOWTO

SwyxConnect configuration update for SwyxWare 2011 and 2011 R2 (kb4256)

The information in this article applies to:

  • SwyxWare 2011 R2
  • SwyxWare 2011
  • SwyxConnect 1724
  • SwyxConnect 1723
  • SwyxConnect 1722

[ Summary | Information ]


Summary

This article describes the SwyxConnect device configuration for the usage with SwyxWare 2011 or 2011 R2.


Information

1. Use one of the following quickstarts for the initial SwyxConnect configuration:

SwyxConnect 1722

SwyxConnect 1723

SwyxConnect 1724

 
Open the SwyxWare Administration once the initial SwyxConnect configuration is completed.

2. Every SwyxWare user who uses an ISDN or Analogue phone which is connected to SwyxConnect must disable the voice encryption feature.
 

img-672
Click to enlarge...
Furthermore if one of the devices is a fax, the user setting "Prohibit T.38 reinvite by sender" has to be enabled.
 
img-672
Click to enlarge...

3. Run the Swyx LANconfig Tool and open the configuration dialog for the corresponding SwyxConnect device. Select "VoIP Call Manager -> Lines" in the menu. Click on the "SIP lines" button on the right side. A new window appears. Double-click on the list entry named "WIZ_SWYXWARE_GW". A further window appears. Select the "Codecs" tab. Ensure that only the "G.711 (u-Law) - 64 kbit/s" codec is selected.
img-672
Click to enlarge...


Once you have changed the settings close the "SIP-Line" windows.

4. Select "VoIP Call Manager -> Lines" in the menu. Click on the "SIP-PBX-lines" button on the right side. A new window appears. Double-click on the list entry named "WIZ_SWYXWARE-PBX". A further window appears. Select the "Codecs" tab. Ensure that only the "G.711 (u-Law) - 64 kbit/s" codec is selected.
img-672
Click to enlarge...


Once you have changed the settings close the "SIP-PBX-Line" windows.

5. Select "VoIP Call Manager -> Codecs" in the menu. Ensure that only the "G.711 (u-Law) - 64 kbit/s" codec is selected.
img-672
Click to enlarge...


Once you have changed the settings close configuration dialog and Swyx LANconfig Tool.
The configuration update has been completed now.

 

Notice regarding T.38 (FaxOverIP protocoll):
Of course the transmissing of fax with help of the T.38 FaxOverIP protocoll is still possible and supported. The previous configuration steps do not turn off T.38 support.
 


Comment

Comment on this article



If we have any follow-up questions, where can we contact you?

E-Mail Address (optional)


Note

This feedback form can't be used for support requests. Those requests must be directed to your Swyx reseller or distributor.