resetting L400 to factory defaults (kb3221)

The information in this article applies to:

  • SwyxPhone L400

[ Summary | Information ]


The procedure to reset a L400 IP phone to factory defaults is as follows:


  • leave the phone connected with power as well as to the network
  • press key's 1 3 0 at the same time, enter the Admin password 123456 and confirm by pressing #
  • Now, the LED's should all blink. If not, try the procedure again.
  • Now - resuming all LED's are blinking - to reset the phone, pres 2 8 9 at the same time. The LED's should stop blinking. (if not, try it again)
  • Then enter the reset passwort 124816 and confirm by pressing #. The phone restarts with factory defaults.


Comment on this article

If we have any follow-up questions, where can we contact you?

E-Mail Address (optional)


This feedback form can't be used for support requests. Those requests must be directed to your Swyx reseller or distributor.